Kleiderschrank Breite 240 Cm

A wardrobe with a width of 94-1/2 in (2400 mm)(or 7 ft 10-1/2 in / 240 cm) is a large-format piece of furniture that typically serves as the primary bedroom storage system. In room planning, this dimension requires a clear wall width of at least 98-7/16 in (250 cm) to ensure smooth assembly and alignment. A wardrobe closet of these dimensions provides sufficient volume for the entire wardrobe of two people, including hanging clothes, folded items, and seasonal textiles.

At a width of 7.87 ft (2.4 m), traditional hinged doors reach their ergonomic and structural limits. Therefore,sliding wardrobe doorsare primarily used in this segment. This design transfers the weight of the doors to floor tracks and saves room space by eliminating the swing radius.

Room Planning and Dimension Specifications for 94-1/2 in (240 cm) Wide Wardrobes

Before assembly begins, the room must be precisely measured. A 94-1/2 in (2400 mm) wide cabinet body does not only require space in width. The standard depth for a full-sized bedroom wardrobe is 23-5/8 in (60 cm). This dimension is necessary so that clothes hangers can hang on the closet rod without rubbing against the back panel or front doors when closing.

System heights vary significantly. Standard cabinet frames often range between 78-3/4 in (200 cm) and 92-29/32 in (236 cm). If you are planning floor-to-ceiling solutions, specialized front panels are used. This allows for installations with heights up to 108-1/4 in (2750 mm). For rooms with lower ceiling heights or sloped ceilings, a low-height wardrobe is often required. In such cases, it is advisable to rely oncustom sliding wardrobe doors, where the tracks and panels are cut to the exact millimeter specifications of the room.

The area surrounding the wardrobe also plays a key role. If you are planning space-saving wardrobes for small rooms, sliding door technology is essential. While a 23-5/8 in (60 cm) wide hinged door projects an additional 23-5/8 in (60 cm) into the room when opened, a sliding door requires zero extra space. This allows you to place a bed or an additional 31-1/2 in (80 cm) wide sideboard at a distance of just 27-9/16 in to 31-1/2 in (70 cm to 80 cm) opposite the wardrobe while keeping the walkway usable.

Door Systems: Sliding Doors vs. Hinged Doors

With a total width of 94-1/2 in (2400 mm), the wardrobe is typically divided into several bays or sections.

Hinged Doors and Hinge Technology

If you plan a traditional wardrobe with hinged doors, the 94-1/2 in (240 cm) width is usually split into four 23-5/8 in (60 cm) cabinet frames or into two 39-3/8 in (100 cm) frames and one 15-3/4 in (40 cm) frame. Concealed wardrobe hinges (cup hinges) are used here. For a standard door made ofparticle board(5/8 in or 23/32 in / 16 mm or 18 mm thickness), at least four to five hinges are required per door to prevent sagging.

The types of wardrobe door hinges vary depending on the overlay application:

• Full Overlay:The door fully covers the cabinet side wall.
• Half Overlay (Dual):Two doors share a single center partition wall (half overlay).
• Inset:The door sits flush inside the cabinet opening between the side walls.

For modern furniture construction, soft-close wardrobe hinges are used almost exclusively today. These hinges feature an integrated damper inside the hinge cup (usually a 1-3/8 in / 35 mm bore) or in the hinge arm. They cushion the door starting from an angle of about 30° and pull it closed smoothly and silently.

Sliding Door Systems for 94-1/2 in (2400 mm)

Due to the massive width, many DIYers opt for sliding door systems for this size. A 94-1/2 in (2400 mm) wide front is divided either into three doors at approx. 32-9/32 in (82 cm) each or into four doors at approx. 24-13/32 in (62 cm) each. When closed, the doors overlap by about 25/32 in to 1-3/16 in (20 mm to 30 mm) to prevent gaps leading into the wardrobe interior.

Guidance is provided via two tracks:

1. Bottom Track:Carries the entire weight of the doors. Ball-bearing rollers (wardrobe door bottom rollers) run along this track.
2. Top Track:Serves purely for guidance and prevents the doors from tipping.

Material Selection for Large-Format Door Fronts

The visual impact of a 94-1/2 in (240 cm) wide wardrobe dominates the room. Selecting the right door front materials is therefore crucial for the interior ambiance.

• MFC (Melamine Faced Chipboard / Particle Board):The standard in furniture making. The material is dimensionally stable, scratch-resistant, and available in numerous finishes (e.g., White, Sonoma Oak, Anthracite). A kit like the4x Sliding Wardrobe Doors - H: up to 2750mm W: 2400mm - MFCprovides a durable, matte surface.
• Lacobel Glass:This is back-painted float glass, usually 5/32 in (4 mm) thick, bonded to a substrate panel. A black wardrobe with Lacobel fronts creates visual depth in the room through its strong reflection. The kit3x Sliding Wardrobe Doors - H: up to 2500mm W: 2400mm - Lacobel Blackuses this technology for a sleek, modern look.
• Mirror Glass:Frequently combined with MFC to visually enlarge the room and integrate a full-length dressing mirror function.

Interior Fittings and Hardware

A bare cabinet frame is not yet a functional wardrobe. The 94-1/2 in (2400 mm) width must be structured using smart soft-close wardrobe fittings.

• Closet Rods:For spans over 39-3/8 in (100 cm), rods should be supported with a center bracket attached to the upper shelf; otherwise, they may sag under the weight of heavy winter coats.
• Drawers:A wardrobe with drawers offers the best access to undergarments and socks. Drawer slides are used here. Undermount drawer slides with soft-close cushioning are ideal for cabinet making. They mount invisibly beneath the drawer box bottom and support 66 lbs to 88 lbs (30 kg to 40 kg) depending on the model.
• Shelves:Secured using shelf pins (typically a 3/16 in / 5 mm pin size) in aline-boring grid (System 32). For a width of 94-1/2 in (240 cm), a material thickness of at least 23/32 in (18 mm)—or ideally 7/8 in (22 mm)—is recommended for adjustable shelves to prevent bowing.

Assembly Guide: Building a 94-1/2 in (240 cm) Wardrobe

Assembling a wardrobe of this size is a project for ambitious DIYers and strictly requires two people. Typical assembly time for the cabinet body and sliding doors is 4 to 6 hours.

Required Tools

• Cordless screwdriver with PZ2 and TX20 driver bits
• Spirit level (at least 39-3/8 in / 100 cm long) or cross-line laser level
• Tape measure (at least 10 ft / 3 m)
• Rubber mallet
• Allen wrench (usually 5/32 in / 4 mm for cam lock connectors)

Step-by-Step Assembly

1. Preparing the Subfloor:Installing the bottom track on a 94-1/2 in (240 cm) wide wardrobe is like laying railroad tracks: if the foundation is not perfectly level, the cars—in this case, the heavy sliding doors—will derail later. Check the floor. If there are irregularities, the cabinet frame must be leveled precisely using adjustable leveling feet (typically adjusted from inside through the bottom panel via an M8 thread).
2. Frame Assembly:Large wardrobes are assembled lying flat on the floor and then raised upright. Pay attention to ceiling height! The diagonal tilt measurement of the wardrobe must be less than the ceiling height; otherwise, the cabinet will jam against the ceiling when raised. If the room is too low, the cabinet must be built in an upright position.
3. Nailing/Screwing the Back Panel:The back panel (typically 1/8 in / 3 mm HDF) provides essential squareness and structural stability. Before securing it, ensure the cabinet frame is perfectly square. Measure both diagonals across the rear; they must be identical in length.
4. Track Installation:Screw the top track flush with the front edge of the top panel. Screw the bottom track onto the bottom panel. Refer to the manual of your specific sliding door system for the exact setback dimension of the bottom track (usually 19/32 in to 31/32 in / 15 mm to 25 mm).
5. Hanging the Doors:First, insert the door into the rear channel of the top track, lift it up, and place the bottom rollers onto the bottom track. Then repeat the process for the front doors.
6. Adjusting Soft-Close Wardrobe Doors:Screw the dampers (soft-close mechanisms) into the top track. The door catch actuators engage these dampers. Adjust the position of the dampers so that the door closes flush with the outer cabinet side without slamming hard.

Featured Systems for 94-1/2 in (2400 mm) Widths

Ready-to-install door sets are available for constructing door fronts, significantly speeding up assembly.

The4x Sliding Wardrobe Doors - H: up to 2750mm W: 2400mm - MFCset divides the width into four slim panels. This is particularly advantageous when space in front of the closet is limited, as narrower doors block less shelf width while organizing the interior. The melamine-faced particle board finish is resistant to fingerprints.

If you prefer a bolder aesthetic, choose the3x Sliding Wardrobe Doors - H: up to 2500mm W: 2400mm - Lacobel Blackset. Dividing the space into three doors at approx. 32-9/32 in (82 cm) wide creates a cleaner, more minimalist seam pattern. The black Lacobel glass reflects light and fits seamlessly into modern, pared-down bedroom concepts.

Alternatives and Additional Size Systems

A 7.87 ft (2.4 m) wide wardrobe does not fit in every room. If space is limited, your layout plans must be adjusted. Compact systems work well for smaller rooms or as secondary storage in a guest room.

A common size for alcoves includes wardrobes from our category for47-1/4 in (1200 mm) wide wardrobes. These are typically designed as two-door units. If slightly more space is available,63 in (1600 mm) variantsoffer a great compromise between footprint and storage volume. For medium-sized bedrooms,70-7/8 in (1800 mm) systemsare the standard, as they neatly accommodate three 23-5/8 in (60 cm) wide cabinet modules.

If you have non-standard ceiling heights or uneven alcove dimensions, opting forcustom sliding wardrobe doorsis the cleanest technical approach to utilize every last fraction of an inch.

Frequently Asked Questions (FAQ)

Can I trim sliding doors to width myself?For systems with aluminum frames and MFC panels, width trimming is theoretically possible for experienced DIYers using a table saw. The horizontal profile extrusions must then also be cut down using a hacksaw. For door fronts made of Lacobel glass or mirrors, subsequent trimming is impossible, as the glass would shatter during cutting.

How does a custom build differ from an Ikea Pax Wardrobe?An Ikea Pax wardrobe relies on predetermined cabinet dimensions (19-11/16 in, 29-1/2 in, 39-3/8 in / 50 cm, 75 cm, 100 cm) and fixed heights (79-1/8 in, 92-29/32 in / 201 cm, 236 cm). When designing a wardrobe yourself using oursliding door sets, you have complete freedom in height (up to 108-1/4 in / 2750 mm) and can tailor the frame exactly to your ceiling height. Additionally, you can choose the particle board thickness yourself (e.g., 3/4 in / 19 mm instead of 23/32 in / 18 mm for greater rigidity).

What is the difference between push-to-open and soft-close?These two systems are often confused, but they are mutually exclusive. Soft-close wardrobe hinges (cushioning) gently pull the door closed during the last few inches of travel. Push-to-open (tip-on) is a touch latch mechanism for handleless fronts: you press against the door, and it pops open slightly. A hinge can feature one or the other, but not both at the same time.

Why are my sliding doors rubbing after assembly?If sliding doors drag or rub, the issue almost always stems from the alignment of the bottom track. If the bottom floor panel sags in the middle, the doors tilt toward each other. Check the surface with a spirit level. Most bottom rollers can also be height-adjusted by +/- 3/16 in (+/- 5 mm) using an adjustment screw (PH2 Phillips) to compensate for minor irregularities.

How many doors are optimal for 94-1/2 in (2400 mm)?This depends on your interior layout. If you build four 23-5/8 in (60 cm) wide cabinet modules, four doors (like in the4x Sliding Wardrobe Doorsset) are ideal, as each door opens exactly one cabinet section. On the other hand, if you build three 31-1/2 in (80 cm) wide sections, you should choose three doors (like in the3x Sliding Wardrobe Doorsset). This ensures you always have direct access to a complete bay without a door obstructing the opening.